True TD-50-18-HC 50" Forced Air Bottle Cooler - Holds (396) 12 oz Bottles, Lid Locks, 115v

This is a great cooler

This cooler works great and fit in to the spot under the bar perfectly!!

Excellent Product-Great Value-USA Made :)

I am writing this review as a commercial refrigeration repair person, you should listen to what I say now for free because if I or my colleagues have to tell you in person, its going to cost you hundreds of dollars per hour! I have used and serviced True products for over 20 years now. True's parts are available, most can be obtained locally for any repairs needed and its a quality, made in USA product, keeping Americans employed which is extremely important to me. If you install your equipment properly, DO MAINTENANCE every three to six months you should get a long life 10+ years from these units. Remember this equipment is making YOU money daily, YOU need to invest back into the life of your equipment and do the maintenance, 90% of all service calls are due to lack of maintenance, your equipment gets too hot and like acid in a body, corrodes from the inside out. So start this quality purchase off right, have it installed by a proper REFRIGERATION technician and enjoy the years of life and $$$ this equipment is going to make for you. If you have a bad experience with this product its because you didn't maintain it. I will continue to buy True products, I highly recommend them.

Good cooler, serviceability not so much.

Straighten the drain for cleaning. Use expanded metal mesh for the dividers instead of current wire setup, bottles get hung up. Cooling works well. Cost effective for us. Would like to see annual energy costs listed for all units in terms of Kw consumed as all coolers run 24/7. When cooling cans, the products stepped rear wall traps cans under it.

bad design, please consider suggestions for higher rating

Hello, Please consider for product improvement to True underbar bottle coolers.. 1, Cooler interior rear side is not flat (don't stack properly). 2. Cooler bin dividers too wide (allow bottle caps to fit through/spillage).. 3. Drain difficult to clean. Your True under bar coolers are designed with the rear interior of the cooler not flat, this causes products such as bottles to not stack properly. nearly every shift! Also, the dividers between the cooler bins are just wide enough to allow bottle caps to fit through them after they fall over from not stacking properly because of the aforementioned issue of the interior rear not being flat. Shouldn't the dividers be just small enough to NOT allow bottle caps to fit through?! So the falling product makes for extra work to keep restacking, also increased spillage when the bottles fall. If the bottles fall and go through the divider the cap is at risk of coming off when the bottle is pulled back through the divider. Once again, this causes spillage. How to clean the spillage? Pull ALL the bottles out to clean the bottom of the cooler! That's more work, only to clean it and get it stacked again, and then have it happen again, over and over again. Your coolers are TRULY poorly designed. I can not recommend them, and will shop for brands that are designed in a more efficient manner and practical for staff. Also, the drain is too close to the side wall, making it difficult to get a full size plunger on it. So a small plunger is required, but even a small plunger is too big to get on top of it properly. Also, the drain does not go straight down to below the cooler, it makes turns on it's way out. This increases clog areas, and makes draining more difficult. A shorter run, straight drain that goes straight down would be beneficial because it would have a shorter run, and also would not go against gravity. Also, a pipe tube brush could be used to clean it if it was a straight drain, in addition to or instead of a plunger. A

Beverage Cooler

Great addition