Construction: Heavy duty construction includes stainless front (doors and grilles) with #3 finish.; Exterior sides are steel with gray, acrylic finish. Exterior top, back, and bottom are galvanized steel.; Exterior mounted thermometer is digital type.; Interior cabinet liner is anodized aluminum finish.; Interior pilasters are "regular" type.; Interior shelves are steel wire-coated.; Cabinets are insulated with R22 foamed-in-place polyurethane insulation, 2" minimum thickness.; All doors are "full size" unless specified "half size" and include keyed door locks as standard with solid doors.; Doors attach to cabinet on cam lift hinges.; Hinges permit doors to stay open at 120 degrees and gravity self-close.; A plug-in type, vinyl magnetic gasket is attached to each door.; Shelves are adjustable on 1/2" centers.; Traffic tough work flow handle is standard.; Door openings include low wattage, anti-condensate heaters.; A switch located at the top of each full door opening activates light and shuts off evaporator fan motor (s) when door is opened.; Six inch, adjustable, corrosion resistant legs are standard.; A 9 foot cord is provided with 115-60-1 models.; With 115/208-230 models, a J box is provided for hard wire connection (4 wire system).
Refrigeration: Unit’s system is located at top of cabinet.; A pressure limiting TXV (thermal extension valve) is used to meter refrigerant between condenser and evaporator.; Defrosting is accomplished with electric heaters.; Defrost is time initiated, temperature terminated.; A time termination is provided as a backup fail-safe.; Evaporator fans are delayed from restarting until coil is adequately chilled down.; Operation of compressor is governed by temperature control behind front grill.; Hot gas (non-electrical) condensate evaporator is located at top of cabinet.; Pressure relief port is provided to make rapid reentry possible.
Air Distribution: Beverage-Air’s unique down-duct air distribution provides the ideal environment for food preservation.; Refrigerated air is discharged from an insulated evaporator coil compartment located above the interior top of cabinet into a distribution plenum.; From the plenum, air is discharged down both sidewalls one half way back.; In two section models, 3-way air discharge is accomplished with an additional down duct located on the center back wall from the discharge plenum for the floor.; In three section models, 4-way air discharge is accomplished with two additional down ducts located on the back wall.; Air is returned upward across the full width of the interior into a louvered plenum assuring even temperatures throughout the cabinet.
Energy Efficiency/Compliance: The manufacturer of this product has NOT certified it to meet the California Energy Commission currently applicable efficiency standards. Please contact customer service for assistance in finding a similar product that is certified to meet these standards if you desire a compliant product.
Additional/Export Voltages: Available for an additional cost & a 4 - 6 week lead time; please contact customer service.
Warranty: This product carries a 1 year parts and labor warranty with an additional 4 year warranty on the compressor.

State and local sales tax will be collected on the sale of Beverage-Air products in all 50 states per the requirements from the Carrier Corporation and it’s subsidiary Beverage-Air. The sales tax will show on the automated invoice only for sales within the state of Tennessee. Read more about sales tax collection by KaTom.