|
64" Undercounter Refrigerator,
2 Section / 4 Drawers
Image shown with doors,
Model UCD4464N comes with 4 drawers
Photo May Include Optional Accessories!
THIS PRODUCT TYPICALLY SHIPS IN 5 - 10 DAYS OPTIONS & ACCESSORIES:
-
18″ wide single tier overshelf
-
Stainless steel finish on back
-
Plastic laminate on front
-
Additional wire shelves
-
Door lock
-
36″ height available for UC
-
Cutting tops/boards ″ composite
or polyethylene
-
220V/50 Hertz electrical system
*Inclusion of this option will alter
electrical specifications of the unit.
Features, Options & Specifications
Subject to Change Without Notice
|
STANDARD FEATURES:
-
Exterior top is one-piece, 22-gauge stainless steel with integral 2.12″ (5.1cm) square nosing at the front.
-
Exterior back and bottom is two-piece 24-gauge galvanized steel. Exterior ends are stainless steel.
-
Interior sides are thermoformed ABS plastic with integral shelf supports. Base is fully insulated with high-density foamed in place polyurethane.
-
Refrigeration system uses HFC-404A refrigerant. Compressor is 1/2 H.P., with condenser coil and condensate evaporator mounted on rear of the cabinet. Evaporator coils and temperature control are located on the interior rear wall of the cabinet. Refrigerant flow is controlled by a capillary tube. Cabinet maintains an interior cabinet temperature of 36°F to 40°F (2°C to 4°C).
-
Electrical connections are 115 volt, 60 Hertz, single phase. Unit has an 8″ (2.4m) long electrical cord and NEMA 5-15P plug.
-
Casters: Equipment is mounted on 2″ (5.08cm) diameter casters, with front three locking. Equipment clearance above the floor is 2.5″ (6.35cm).
The following applies to four drawer models only
-
Drawer fronts have a 22-gauge stainless steel exterior, with thermoformed ABS plastic interior liner. Drawer frames are 14-gauge stainless steel. Drawer slides are 14-gauge stainless steel , with stainless steel bearings. Each top drawer will hold two 12″ x 20″ (30.5cm x 50.8cm) pans 4″-6″ (10.1cm-15.2cm) deep. Each bottom drawer holds two 12″ x 20″ (30.8cm x 50.8 cm) pans 4″ (10.6cm) deep. Pans are supplied by others.
|
