|
Short Form Specifications: Exterior Top is one-piece, 22-gauge stainless steel with integral 2.12″ (5.1cm) square nosing on the front.
Exterior Back and Bottom are two-piece 24-gauge galvanized steel. Exterior ends are stainless steel
Interior Sides of Door Models are thermoformed ABS plastic with shelf supports. Base is fully insulated with high-density foamed in place polyurethane
Refrigeration system uses HFC-404A refrigerant. Compressor is 1/3 h.p. for door models and 1/3+ h.p. for drawer models, with condenser coil and condensate evaporator mounted on rear of the cabinet. Evaporator coil and temperature control are located on the interior rear wall of the cabinet. Refrigerant flow is controlled by an expansion valve. Cabinet maintains an interior cabinet temperature of -5°F to 0°F (-21°C to -18°C).
Electrical Connections are 115 volt, 60 Hertz, single phase. Unit has an 8″ (2.4m) long electrical cord and NEMA 5-15P plug.
Casters Equipment is mounted on 2″ (5.08cm) diameter front locking plate casters. Equipment clearance above the floor is 2.5″ (6.35cm).
Doors have a 22-gauge stainless steel exterior, with thermoformed ABS plastic interior liner. Cabinet of door models has one adjustable epoxy-coated wire shelf.
Drawers: have a 22-gauge stainless steel exterior with thermoformed ABS plastic interior liner. Drawer frames and slides are 14-gauge stainless steel, with stainless
steel bearings. Drawer units have two drawers. Top drawer will hold two 12″ x 20″ (30.5cm x 50.8cm) pans 4″-6″ (10.1cm-15.2cm) deep. Bottom drawer holds two 4″ (10.1cm) deep full size pans. Pans are supplied by others.
Features, Options & Specifications Subject to Change Without Notice. |
