|
48" Refrigerated Base,
Flat Top, 2 Section,
4 Drawers
Image Shown Model 4448N8 with Doors
Photo May Include Optional Accessories!
THIS PRODUCT TYPICALLY SHIPS SAME OR NEXT DAY
| OPTIONAL ACCESSORIES: |
- 18″ wide single tier overshelf
- Stainless steel finish on back
- Plastic laminate on front
- Additional wire shelves
- Door lock
- *220V/50 Hertz electrical system
* Inclusion of this option will alter electrical specifications of the unit..
Features, Options & Specifications
Subject to Change Without Notice
|
|
Up-charge and lead times may apply. |
|
Short Form Specifications: Exterior Top: is one-piece 22-gauge stainless steel with integral 2.12″ (5.1cm) square nosing at the front.
Exterior Back & Bottom: are two-piece 24-gauge galvanized steel. Exterior ends are stainless steel.
Interior Sides: are thermoformed ABS plastic with integral shelf supports. Base is fully insulated with high-density foamed in place polyurethane.
Refrigeration: system uses HFC-404A refrigerant. Compressor is 1/5 H.P., with condenser coil and hot gas condensate evaporator mounted on rear of the cabinet. Evaporator coils and temperature control are located on the interior rear wall of the cabinet. Refrigerant flow is controlled by a capillary tube. Cabinet maintains an interior cabinet temperature of 36°F to 40°F (2°C to 4°C).
Electrical Connection: is 115 volt, 60 Hertz, single phase. Unit has an 8″ (2.4m) long electrical cord and NEMA 5-15P plug.
Casters: Equipment is mounted on 2″ (5.08cm) diameter plate casters with front two locking. Equipment clearance above the floor is 2.5″ (6.35cm).
Drawers: have 22-gauge stainless steel exterior with thermoformed ABS plastic interior liner. Drawer frames are 14-gauge stainless steel. Drawer slides are 14-gauge stainless steel with stainless steel bearings. Each drawer holds one full size 12″ x 20″ x 4″ deep (30.5cm x 50.8cm x 10.2cm deep). Pans are supplied by others.
|
