48in Salad Top Refrigerator, 18 Pan, Mega Top

STANDARD FEATURES:

• Exterior Top is one-piece 22-gauge stainless steel with integral 2.12″ (5.1cm) square nosing on the front. Top has one telescoping cover, with three openings to accept eighteen 1/6 size plastic pans 4″-6″ (10.1-15.2cm) deep or three 12″ x 20″ (30.5cm x 50.8cm) full size pans, 4″-6″ (10.1-15.2cm) deep. Adapter bars and 1/6 size pans are supplied by Delfield. Lid is constructed of 20-gauge stainless steel. Temperature in top openings maintains 33°F (1°C) to 41°F (5°C), with pans recessed 2.5″ (6.4cm) at 86°F ambient room temperature, meeting NSF 7 requirements. One 48″ x 8″ x .5″ (121.9cm x 20.3cm x 1.3cm) plastic cutting board is mounted on the top at the front edge.

• Exterior back and bottom are two piece 24-gauge galvanized steel. Exterior ends are stainless steel..

• Interior Sides are thermoformed ABS plastic with integral shelf supports. Base is fully insulated with high- density foamed in place polyurethane.

• Door has a 22-gauge stainless steel exterior, with thermoformed ABS plastic interior liner. Cabinet has one adjustable epoxy-coated wire shelf.

• Refrigeration Refrigeration system uses HFC-404A refrigerant. Compressor is 1/5 H.P., with condenser coil and hot gas condensate evaporator mounted on rear of the cabinet. Evaporator coils and temperature control are located on the interior rear wall of the cabinet. Refrigerant flow is controlled by a capillary tube. Cabinet maintains an interior cabinet temperature of 36°F to 40°F (2°C to 4°C).

• Electrical connection is 115 volt, 60 Hertz, single phase. Unit has an 8″ (2.4m) long electrical cord and NEMA 5-15P plug.

• Casters: Equipment is mounted on 2″ (5.08cm) diameter plate casters with front two locking. Equipment clearance above the floor is 2.5″ (6.35cm).

• Doors have a 22-gauge stainless steel exterior, with thermoformed ABS plastic interior liner. Cabinet has one adjustable epoxy-coated wire shelf per door opening.

•  Drawers have 22-gauge stainless steel exterior with thermoformed ABS plastic interior liner. Drawer frames are 14-gauge stainless steel. Drawer slides are 14-gauge stainless steel with stainless steel bearings. Each top drawer holds one 12″ x 20″ (30.5cm x 50.8cm) pan 4″ -6″ (10.1cm-15.2cm) deep. Each bottom drawer holds one 12″ x 20″ (30.5cm x 50.8cm) pan 4″ (10.1cm) deep. Pans are supplied by others.