|
Short Form Specifications: Exterior Top: is one-piece, 22-gauge stainless steel with integral 2.12″ (5.1cm) square nosing on the front. Top of drawer unit has one opening to accept six 1/6-size 4″ deep pans or one 12″ x 20″ full size pan. Top of door unit has one opening to accept six 1/6-size 4-6″ deep pans or one 12″ x 20″ full size pan. Adapter bars and 1/6 size pans are supplied by Delfield. Lid is constructed of 20-gauge stainless steel. Temperature in top opening to maintain 33°F (1°C) to 41°F (5°C), with pans recessed 2.5″ (6.4cm) at 86°F ambient room temperature, meeting NSF 7 requirements. One 27″ x 8″ x .5″ (68.6cm x 20.3cm x 1.3cm) plastic cutting board is mounted on the top at the front edge.
Exterior Back & Bottom: are two-piece 24-gauge galvanized steel. Exterior ends are stainless steel.
Interior Sides: are thermoformed ABS plastic with integral shelf supports. Base is fully insulated with high-density foamed in place polyurethane.
Refrigeration: system uses HFC-404A refrigerant. Compressor is 1/5 H.P., with condenser coil and hot gas condensate evaporator mounted on rear of the cabinet. Evaporator coils and temperature control are located on the interior rear wall of the cabinet. Refrigerant flow is controlled by a capillary tube. Cabinet maintains an interior cabinet temperature of 36°F to 40°F (2°C to 4°C).
Electrical Connection: is 115 volt, 60 Hertz, single phase. Unit has an 8″ (2.4m) long electrical cord and NEMA 5-15P plug.
Casters: Equipment is mounted on 2″ (5.08cm) diameter plate casters with front two locking. Equipment clearance above the floor is 2.5″ (6.35cm).
Doors: have a 22-gauge stainless steel exterior, with thermoformed ABS plastic interior liner. Cabinet has one adjustable epoxy-coated wire shelf.
Features, Options & Specifications Subject to Change Without Notice. |
